Analysis and Treatment of Causes for Different Sounds of Agricultural Vehicles
hot dipped galvanized welded rock cage
Welded gabions are
wire mesh containers welded with high quality steel mesh.They can be
filled on site with hard durable stone materials to form mass gravity
retaining structures. Owing to their inflexibility, welded gabion can
not adapt to differential settlement or be used in water courses ,In
comparison with woven wire gabions, welded gabion offer a higher
strength. In order to meet different project requirements, various wire
diameters and unit sizes are available for welded gabion. It is composed
of Welded Mesh panel and spring steel lacing wire.
As
a highly-accomplished wire mesh exporter, Kingdelong was established
jointly by China and South Korea in 1986, Our strategic location in
Anping County,Hebei province is only 300KM away from Beijing and
Tianjin, which offers us very competitive advantages both in trade and
logistics. Through two decades of hard work, Kingdelong company had
evolved into one of China`s largest wire mesh manufacturing
companies,Covering an area of over 200,000㎡, certificated by ISO 9001
& ISO 14001,as well as more than 450 diversified production
machines, which are either imported from foreign countries or developed
in-house.Wire mesh products find applications in a wide range of
industries, from Pharmacy to petroleum and chemical to textile. Welded Gabion Mesh,Welded Wire Mesh,Mesh Welded Gabion Wire,Gabion Retaining Wall Wire ANPING KINDELONG WIRE MESH CO.,LTD. , https://www.wire-mesh.org
1, "squeak" dull sound Â
This is the sound of the valve foot clearance being too large or too small. According to the manufacturer's data, adjust the clearance between the inlet and outlet doors. The general gap is between 0,012-0,022 mm. Â
2, "bang" loud noise Â
This kind of sound is usually an exhaust pipe or muffler. The explosion of the engine cannot be eliminated due to the explosion. The exhaust pipe and muffler should be checked immediately. Â
3, "啾啾" sharp sound Â
The reason that the sound of the belt and the belt pulley rubs is that the belt must be replaced or the gap must be adjusted due to the wear of the belt or improper adjustment of the gap. Â
4, "咔嚓" noise Â
The reason for the failure of this sound display is not single, it may damage the motor air-conditioning compressor or the water pump bearing (the marble disk), or it may be that the vehicle has been driven in the state of water loss or oil loss, which causes the size of the crankshaft to be damaged. The noise emitted from the neck and shaft pin should be checked and repaired immediately. Â
5, "咣咣" percussion Â
It may be that the sound produced by the crankshaft journal and the bearing shell clearance is too large and the clearance between the journal and the bearing shell should be checked. Â