What is the working principle and use characteristics of the permanent magnet dewatering tank?

October 22 18:00:14, 2024

The selection process of the permanent magnet dewatering tank is: the slurry is fed into the ore by the feeding direction along the tangential direction, and the slurry is evenly spread on the tower-shaped magnetic pole. Under the combined action of magnetic force and gravity, the magnetic ore particles overcome the resistance of the rising water flow and are sucked on the magnetic system. When they are sucked enough, they fall into the grit and flow out through the discharge port. The smaller particle size in the non-magnetic material is moved upward by the action of the rising water flow, and is discharged by the overflow tank, and the non-magnetic material having a large particle size is less likely to rise, and thus is also discharged with the magnetic material.
The permanent magnet dewatering tank is mainly used to remove fine ore and slime, but cannot remove large gangue, and the ability to discard coarse tailings is not as good as that of magnetic separator. In order to cause the rising water flow, the water supply device is always water supply, and the water consumption is large. The concentrate grade of the permanent magnet dewatering tank is not as high as the magnetic separator, but the recovery rate is higher than that of the magnetic separator.
2inch Tow Strap
Our Heavy Duty Tow Strap made from high-level Polyester, 2 inch wide, 20ft long heavy duty winch strap with no hook, 20,000 pound capacity.Our traction belt has excellent quality and long-lasting performance.Our tow strap kit is made from tightly moisture and heat resistant Polyester material. Wash and keep it clean to elongate its lifespan, Reinforced loops protect against abrasion.
2Inch Tow Strap,Tow Truck Straps,Vehicle Tow Strap,Tow Straps With Hooks,Tow Rope For Truck,Tow Hook Strap
WINNERLIFTING SAFETY EQUIPMENT CO., LTD. , https://www.webesteu.com