Chu Sheng compressed garbage truck performance introduction



Xigong Chusheng compressed garbage truck performance introduction

1. The electromechanical-hydraulic integration technology with one-touch operation and the use of the microcomputer-controlled intelligent control program of the microcomputer can automatically complete the single-cycle or continuous-cycle garbage loading operation with a single button press. The operation is very convenient.

2,
High compression ratio, waste compression ratio of up to 1:2.5, domestic garbage after compression, the density of up to 0.5-0.8t/m3, load capacity.

3,
High loading efficiency, one cycle time for loading operation is less than 30 seconds, and one cycle time for unloading operation is less than 40 seconds.

4,
Two operating modes, electric button operation and handle operation, are set to facilitate debugging and maintenance. Both operation modes can work independently. When the electrical system fails, the operation can be continued with the handle to ensure the work efficiency.

5,
In the cab and the rear of the vehicle, operation buttons are set separately. When unloading garbage in the garbage dump, the operator does not need to get off the vehicle. The whole process of unloading the garbage can be completed in the cab, which is very convenient.

6,
Filler and car body joints adopt special-shaped sealing strips to be hydraulically locked so that garbage can be reliably sealed in the box body to prevent leakage of waste and sewage.

7,
In the hydraulic circuit of the lifting filler, there is a safety device that prevents bursting of the tubing and sudden drop of the filler to improve the safety of use.

8,
The emergency brake button is specially set on the car to stop the garbage packing device in any state or any position and to ensure the safety of the operator and the equipment.

9,
Imported parts are used for key control components to ensure that the garbage truck can operate stably and reliably.  



Tungsten Carbide Roll Rings

Tungsten Carbide Roll Rings, also known as hard alloy roller ring, has been widely used in the rolling production of high-speed wire, bar, threaded steel, seamless steel pipes, etc. due to its good wear resistance, high-temperature hardness, heat fatigue resistance, thermal conductivity, and high strength.
The Tungsten Carbide Roll Rings we produce mostly come in two series: WC Co and WC Co Ni Cr, with Co and Co Ni Cr as binders ranging from 6wt% to 30wt%. From a usage perspective, hard alloy rollers have good comprehensive mechanical properties, with a bending strength of over 2200 MPa and an impact toughness of (4-6) × At 10 ^ 6J/m ^ 2, the Rockwell hardness (HRA) can reach 78~90. During the high-speed wire rolling process, the single groove steel passing amount is much higher than that of cold hard cast iron or high-speed steel rollers.

Tungsten Carbide Sleeve,Tungsten Carbide Roller, Steel Rebar Rolling,Steel Wire Rod Rolling,WC Roller

Luoyang Golden Egret Geotools Co., Ltd , https://www.xtcwelding.com