Electric pumping pump pumping liquid reasons and solutions
Galvanized + Painted screw pin anchor shackles are priced to move. Made of galvanized carbon steel, the anchor shackle is a tough and durable accessory for nylon slings, as well as polyester slings. Paired with a lifting sling and tow straps, they help protect the eyes of your sling from wear and tear on clevis hooks. They come in various sizes and strengths ranging from 3/16" - 2-1/2" and 1/3 Ton - 55 Ton. This clevis can be used in many applications such as industrial, agricultural and marine applications. Shackle color may vary. D Shackle White,Clevis Shackle White,Bow Shackle Black,Black Lifting Shackles WINNERLIFTING SAFETY EQUIPMENT CO., LTD. , https://www.winnerslackline.com
Electric pumping pump pumping liquid can not draw the following reasons:
I. Electric pump does not run after receiving power supply 1. The power is off (power is not turned on); The solution is to repair the power (turn on the power).
2. Switch bad or not work; solution is to repair or replace the switch.
3. Brush wear or can not be reset; the solution is to replace the brush or adjust the return.
4. armature or (stator) coil burnout; solution to replace the armature coil in the stator.
5. Stator coil short-circuit; solution such as broken in the presence of welding can be used, or need to rewound.
Electric pump after the power of abnormal sound and does not rotate or turn very slowly 1. Switch contacts burn out; solution to repair or replace the switch.
2 mechanical parts stuck; solution to check and trim the part being card.
3. Into the water pipe or drive shaft debris; solution to clean up debris.
4. A small amount of armature short circuit or open circuit; solution to repair or replace the armature.
5. Low power supply voltage; solution to adjust the power supply voltage.
Third, the motor rotation shaft does not turn 1 coupling (gimbal) damage; solution to exchange coupling (gimbal).
2 shaft thread breakage; solution to replace the shaft or short axis.
Four commutator bad damage or sparks 1 armature short circuit or open circuit; solution to repair the armature.
2. Commutator surface is not smooth; solution to remove debris make the commutator surface smooth.
Vibration, excessive noise or liquid leakage 1 liquid emptying; solution to stop the pump.
2. Motor overload (overload operation) solution; check the liquid viscosity, such as viscosity too high for high viscosity pump, check the head.
3. Bearing wear (such as the ring caused by damage); solution to replace the bearing (replace the ring).
4. Skeleton oil seal worn or damaged due to chemical reactions; solution to replace the skeleton oil seal or seal replacement pump.