Preform and Cap Making Machine
Stone Paper TO Circle Binding Notebook Hardcover Paper Stone Notebook,Hardcover Paper Stone Notebooks,Textile Fabric Paper Stone Shenzhen Stone Paper Enterprise , https://www.stonepowersz.com
Full-automatic PET Bottle Blow Molding machine/Blow Molder
Blissum's Bw series are the most stable two-step fully-automatic pet stretch-blow moulding machines(reheat). It has one to six cavities and the maximum capacity of the products is 2L. It can blow bottles in shapes: Carbonated, mineral, pesticide, cosmetics, wide-mouth, hot filling, and other packing containers, which is made of plastic of crystalline type, such as PET and PP etc.
Â
Conguration list of PET Bottle Blow Molding machine/Blow MolderÂ
A). PLC colour display: Siemens(Germany)
B). Pneumatic parts: FESTO(Germany)
C). Controller of preform transfer: Servo motor National(Japan)
D). Other electric parts are all world-famous brand
Â
Feature of Full-automatic PET Bottle Blow Molding machine/Blow Molder:Â
1. Stable performance with advanced PLC.Â
2. Conveying preforms automatically with conveyor.Â
3. Strong penetrability and good and swift distribution of the heat by letting the bottles rotate by itself and revolute in the rails simultaneously in the infrared preheater.Â
4. High adjustability to enable the preheater to preheat preforms in shapes by adjusting the light tube and the length of the reflecting board in the preheating area, and eternal temperature in the preheater with an automatic thermostatic apparatus.Â
5. High safeties with security automatic-locking apparatus in each mechanical action, which will make the procedures turn into a state of safety in case of a breakdown in certain procedure.Â
6. No contamination and low noise with the air cylinder to drive the action instead of the oil pump.Â
7. Satisfaction with different atmospheric pressure for blowing and mechanical action by dividing the blowing and action into three parts in the air pressure diagram of the machine.Â
8. Strong clamping force with high pressure and double crank links to lock the mold.Â
9. Two ways of operating: Automatic and manual.Â
10. Safe, reliable, and unique design of the position of valve to make the air pressure diagram of the machine easier to understand.Â
11. Low cost, high efficiency, easy operation, easy maintenance, etc, with automatic technological process.Â
12. Contamination is avoided for the bottle body.Â
13. Ideal effect of the chilling with the chilling system.Â
14. Easy installation and startingÂ
15. Low rejection rate: Less than 0.2 percent.
perform
Main specification of BLIM-1700
Screw A
Screw B
Screw C
Injection Unit
Screw Diameter
mm
40
45
48
Screw L/D Ratio
L/D
24.7
22
20.6
Shot Volume (theoretical)
CM
282
358
407
Injection Weight (PS)
g
262
330
378
oz
9.24
11.6
13.3
Injection Rate
g/s
100
126
144
Plasticizing Capacity
g/s
14
19
23
Injection Pressure
MPa
224
176
155
Screw Speed
rpm
160
Clamping Unit