Spring Torsion Tester Attention During Use

March 13 13:07:53, 2023

In the mechanical testing of building materials and metal materials, due to the good control performance and test precision of the spring torsion testing machine, it has been widely used. In the large iron and steel enterprises, and the quality inspection unit laboratory, the spring torsion testing machine is often more than one The high-load operation was carried out, and most of the testers lacked experience in the maintenance of the equipment. Therefore, problems often occurred, and some users even complained about the problems of the equipment. Actually, the spring torsion testing machine was a combination of optical, mechanical, and electrical high-precision instruments. As long as we have some skills to use it, we will do it.

Here are a few instructions to make:

1. Use appropriate fixtures to complete the corresponding test, otherwise not only the test will not be ideal, but it will also damage the fixture:

Spring torsion testers are generally equipped with fixtures for standard specimens. If non-standard specimens, such as strands, laps, etc., are to be used, additional fixtures must be added. Then there is some excess hardness. The material, such as spring steel, etc., must use special material clips, otherwise it will damage the fixture.

2, cleaning and cleaning:

In the course of the test, some dust, such as oxide scale, metal scraps, etc., are inevitably generated. If they are not cleaned in time, the inequality will cause wear, scratches, etc. on the surfaces of some parts, and more seriously if these dusts enter. The spring torsion tester system will have very serious consequences such as blocking the valve hole and scratching the surface of the piston, so it is necessary to clean it after each use.

3, components should be regularly inspected:

All pressure control valves, pump regulators, and signal devices such as pressure relays, flow control valves, limit switches, and thermal relays should be inspected periodically.

4, its fasteners should be regularly locked:

Frequent vibrations of the specimen after it is broken will often loosen some of the fasteners and must be checked regularly (normally for about 30 working days) to avoid large losses due to loose fasteners.

5. The lead screw and transmission part should be regularly lubricated.

For more information on testing machines, please visit Jinan Zhongchuang Industrial Test System Co., Ltd. or contact the sales department for a sample or more detailed technical solution.

Because of the profession, it is outstanding, Jinan Zhongchuang sincerely serves you!

Plastic Sleeve

Rail Plastic dowel(Rail Plastic Sleeve)

Rail plastic dowel is also called rail plastic sleeve/plastic insert/concrete dowel/ concrete insert, which is a counter-party fastener for a screw spike or anchor bolt, and it is pre-imbedded into the concrete sleeper or wooden sleeper, installed together with Screw Spikes, guide plates and rail clips to fasten the rail tracks.

Plastic Sleeve,Nylon Plastic Dowel,Customized Nylon Lock Dowel,Plastic Nylon Sleeve

Anyang Railway Equipment CO.,Ltd , https://www.ayrailwayat.com