Calorimeter Common Problems and Maintenance Methods
Aluminum plate refers to the aluminum material with a thickness of more than 0.2mm to less than 500mm, a width of more than 200 mm, and a length of less than 16m, which is called aluminum plate or Aluminum Sheet. Aluminum plate with a thickness of less than 0.2mm is called aluminum material, and aluminum plate with a width of less than 200 mm is called row material or strip material (of course, with the progress of large equipment, there are more aluminum plates with a maximum width of 600 mm). Aluminum plate, aluminum rolling plate, Extrusion Aluminum plate for heat exchanger Trumony Aluminum Limited , https://www.szaluminumpipe.com
1. Oxygen Bombs: In addition to cleaning and drying oxygen bombs after each test, the following points should also be noted and inspected:
(1) The oxygen bomb can only be twisted by hand. When the hand feels resistance, it should be stopped. Never try to use the tool to tighten it. After the test is completed, it should be cleaned once.
(2), bomb caps and valve seats should be flushed and wiped dry after use.
(3) Rinse the cup, scrub the threads, and inspect the cup for mechanical damage. Be careful not to invert the cup.
(4) Check whether the seal ring is worn out and damaged during combustion. If there is a leak in the sealed seal, replace it.
(5) Check whether the insulation pad and insulation cover are good or not damaged, and check the insulation regularly.
(6) Periodically conduct a 20.00Mpa water pressure test on the oxygen bomb. After each hydrostatic test, the use time of the oxygen bomb shall not exceed one year (or may not exceed 5000 tests).
2. Calorimeter tube: After the test, the water in the tube should be discharged to the outer tube and wiped dry to keep it clean.
3, test water: It is best to be pure water, and to be regularly replaced to ensure the test reliability and success rate.
Note: In order to fully use the system, the computer equipment must be reliably grounded.
Aluminum plate refers to the rectangular plate rolled by aluminum ingot, which is divided into pure aluminum plate, alloy aluminum plate, thin aluminum plate, medium thick aluminum plate and patterned aluminum plate.