How to deal with surface grinder leak failure?
Sheet Metal Parts,Custom Sheet Metal Parts,Sheet Metal Pressing,Prototype Sheet Metal Parts DONGGUAN TONJA INDUSTRIAL CO.LTD , https://www.tonjaism.com
First, the workbench at both ends of the dust-proof plate gold seepage, the general surface grinder assembly is not careful, fixed dust board gold screws through the ends of the rail, direct oil out from the guide rail, the solution is a flat surface grinder screw wound raw tape hit The adhesive went up again.
Second, the adjustment is too large oil, open the rear fuel tank cover, use a flat-head screwdriver to adjust the oil valve switch, clockwise for the small, otherwise large, the size of the general oil control is the first clockwise rotation and then turn One-fourth can be. The groove groove on the guide rail surface grinder is not opened well. It is too shallow or not open. The oil cannot overflow from the side and should be reopened. The oil hole is blocked, the oil is forced out of the guide rail, and the oil hole is blocked. Is the oil is too sticky or dirty, change the oil type or clean the oil, if it is the old surface grinder is generally too dirty guide rails, clean up the oil on it.
Third, before and after the screw leak, if it is a new surface grinder leakage, generally the screw is not installed before and after the retractable sheath, the two screws did not lock or sealant did not play well, if it is the old surface grinder will replace the screw Sheath, re-seal the sealant.
After a failure, we must find the correct reason and the problem will be solved.