In the past month or so, frequent rainfall has caused inconvenience to the general public. When heavy rainstorms are encountered, vehicles are often seen standing idle on the road in the water to wait for assistance. It must be said that wading in the rainy season is a nightmare for many drivers. In addition to affecting normal travel, the more important thing is that once the vehicle turns off, it will also cause a great deal of damage to the vehicle itself. So, today, the author wants to lead everyone to understand how to wading in the rainy season.

First, for each car, it has its own wading depth. The wading areas that the vehicles can pass through are also different. But in a unified sense, the safe wading depth is based on the height of the vehicle's exhaust pipe. If the height of the stagnant water section does not reach the height of the exhaust pipe, then the phenomenon of flameout does not occur. At this time, driving the vehicle passes without any problem. However, if the water level has exceeded the limit of the depth of the wading depth of its own vehicle, it must not be able to wading. Under such conditions, wading will definitely turn off. After the flameout, not only will it increase the traffic burden, but it will also cause great damage to your car.

Second, if the stagnant water satisfies the conditions for wading, this time the wading should be in the low-end position. The accelerator pedal must not be released and it needs relative stability. This operation is a relatively high requirement for the driver. The purpose is to prevent the engine speed from declining and cause the stagnant water to go out through the exhaust pipe and enter the engine.

Third, as far as possible through the wading road section, follow the preceding vehicle as far as possible, and take the trajectory of the preceding vehicle.

Fourth, if it is a driver of a large vehicle, it also needs to pass through the wading area at a low speed. Although the chassis of a large vehicle is relatively high, if the vehicle is driven at a fast speed, the water level may change. Therefore, for other vehicles with a low chassis, it is very easy to cause the other vehicle to stall.

Fifth, after the completion of the wading, a continuous braking operation step is required. This step is to eliminate the water in the brake and allow the affected braking force to operate normally.

Omega Roll Forming Machine

Omega Roll Forming Machine

Omega Roll Forming Machine, Omega Profile Roll Forming Machine

Botou Xianfa Roll Forming Machine Factory , https://www.rollforming.nl